To Next PageTo Next Page
Need help?Do you have a question about the ICP PAF354000K00A1 and is the answer not in the manual?
General| Brand | ICP |
|---|---|
| Model | PAF354000K00A1 |
| Category | Air Conditioner |
| Language | English |
Specifies required clearances from unit to combustible materials for safety.
Details general installation requirements including leveling and platform needs.
Requirements for installing the unit on ground level platforms.
Requirements for installing the unit on a rooftop structure.
Guidelines for unit placement to ensure adequate airflow and avoid noise issues.
Requirement for a separate, waterproof disconnect switch for the unit.
Proper methods for establishing an electrical ground connection for the unit.
Instructions for connecting high voltage power to the unit's control box.
Guidelines for connecting thermostats and low voltage wiring to the unit.
Guidance on recommended duct velocities and proper sizing for efficiency.
Requirements for insulating outdoor ductwork with wrap and vapor barrier.
Permitted use of flexible connectors and sealing requirements for plenums.
Importance of filters and minimum size recommendations for return air.
Table of blower performance data and speed tap settings for different models.
Instructions for connecting blower motor speed wires for heating and cooling.
How the continuous fan operates in cooling mode for different unit sizes.
Procedure for checking cooling operation, including contactor, compressor, and fan status.
Pre-start checks including blower speed, filters, and access panels.
Describes unit operation during cooling and heating cycles for different models.
Unit cooling operation for different ton models.
Unit heating operation for different ton models.
Continuous fan mode operation for different unit sizes.
Routine checks for air filters and cooling season components.
Instructions for inspecting, cleaning, or replacing air filters.
Monthly checks for condenser coil and condensate drain.
Information on condenser fan motor lubrication and cleaning.
Steps to access and remove the blower motor.
Procedure for removing and replacing blower motor or housing components.
Inspection and cleaning of the circulating air blower.
Electrical schematic for 2 to 3-1/2 ton models.
Electrical schematic for 4 to 5 ton models.
