17
Battery installation
°C
Additional functions: Detailed explanation for Sleep Mode settings
Sleep mode routine - what is it?
If you want Sleep mode to operate only once:
Press the minus sign button . The clock
starts blinking.
Press the right button twice. The programming
row starts blinking and 'Start 1' appears.
Press the SEL button
SEL
in order to select
a switch ON time.
The Start time is activated. Program the switch
ON time using the
and buttons.
If you want Sleep mode to operate
every day:
(Daily feature)
If DAILY has already been selected, stop here.
If DAILY has not been selected, perform all the actions in
the single Sleep mode operation (Follow the arrow)
In this state the FAN symbol blinks
Press the minus button . The clock starts
blinking.
Press the right button three (3) times.
The word DAILY starts blinking.
Press the SEL button
SEL
in order to set
automatic, daily switching ON time of the air
conditioner, according to the time you set for
Sleep mode.
Press the SEL button
SEL
in order to set the switch
ON time and to move to the switch OFF time.
The Stop time is activated. Program the switch
OFF time using the
and buttons.
Press the SEL button
SEL
in order to set
the switch OFF time.
Once you close the flap door on the remote control,
the Daily and Sleep symbols will appear each time
the time period is active.
✓ Remove the battery compartment cover by sliding it off.
✓ Insert two Alkaline AAA 1.5V batteries into the battery compartment,
making sure to follow the polarity markings inside the battery compartment.
✓ Replace battery compartment cover.
✓ Replace batteries whenever 'Low Battery'
indicator appears.
Important
After battery replacement, all last settings are re-gained, except timer
programming, which might not be saved.
If the air conditioner is cooling, the temperature will rise by one (1) degree per hour, or maximum two (2) degrees
from the original set temperature selected.
If the air conditioner is heating, the temperature will drop be one (1) degree per hour, for maximum two (2) degrees
from the original set temperature selected.
To Next Page
Loading...
Need help?
General
