© 2021 ICS®, Oregon Tool Inc. REV12232021 P/N 610794
536-E OPERATOR MANUAL
2
ENGLI SH
Introduction
TABLE OF CONTENTS
SYMBOLS AND LABELS
SAFETY
GENERAL POWER TOOL SAFETY WARNINGS
SAFETY
PRODUCT IDENTIFICATION
ICS 536-E NAMES AND TERMS
UNPACKING AND ASSEMBLY
OPERATION
MAINTENANCE
TROUBLESHOOTING
TECHNICAL SPECIFICATIONS
4
7
8
14
19
26
34
37
39
INTRODUCTION
The 536-E power cutter is designed to cut concrete, stone, and masonry when used
with the appropriate genuine ICS Diamond Chain. Ductile iron pipe may also be cut but
ONLY if using PowerGrit® Pipe Cutting Chain. This is a professional tool and is solely
obtain practical instruction before using the power cutter, as well as reading and
understanding this Operator’s Manual.
Local legislation and/or workplace standards may regulate the use of this power cutter.
Determine what regulations are applicable in the place you work before
using the power cutter.
This instruction manual contains translations of a manual drafted in English and are
technical writing, some terms may not have a like or equivalent meaning as
translated. Therefore, you should not rely on this translation, and should
cross-reference the English version, where relying on the translated instructions could
result in harm to your person or property.
manual, please visit:
https://icsdiamondtools.com/customer-service-support/
To Next Page
Loading...