© 2021 ICS®, Oregon Tool Inc. REV12232021 P/N 610794
536-E OPERATOR MANUAL
25
Unpacking & Assembly
CONNECT TO WATER SUPPLY
The water supply also cools the motor and internal electronics.
the tool has cooled.
particulates.
ICS® power cutters require a continuous water supply to the guidebar and chain for the
key purposes of cooling, lubrication and dust suppression. The potential for airborne
particulates depends on many factors including, but not limited to, the material being
cut, application and cutting environment.
NOTE: Local and/or regional regulation can vary widely. It is the responsibility of the
operator to wear appropriate dust protection applicable in their area and suitable to the
application.
CAUTION
. The single most important
factor an operator can control to increase chain life is to use adequate water
pressure.
Do not exceed water temperature of 104
result in serious burns or scalding.
freezing.
To Next Page
Loading...