680ES OPERATOR MANUAL
41
© 2015 ICS®, Blount International Inc. Specications are subject to
change without notice. REV071315 F/N 577451
Chain Tensioner
Maintenance
STARTER RECOIL HOUSING ASSEMBLY
• To reattach the starter cover assembly, rst pull.
the starter cord out, then hold the starter recoil housing against the crankcase
• Slowly release the starter cord to enable the pulley
to t between the pawls.
• Insert and tighten the screws. Use blue Loctite®
#242.
CHAIN TENSIONER
The chain tensioner can become clogged with concrete slurry during cutting.
• After each use thoroughly ush the chain tensioner with water and apply a
liberal amount of waterproof grease covering the chain tensioner screw.
To Next Page
Loading...
