EasyManua.ls Logo

ICT ICT200DF-12 - Page 22

Default Icon
32 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
22 Innovative Circuit Technology Ltd.
SMTP Server: Enter the name or the IP address of your SMTP server used for
sending outgoing e-mail. (e.g. “smtp.gmail.com”)
SMTP Port: Enter the port used by your SMTP server. (Normally 25)
SMTP Server requires SSL: Check this box if your SMTP server requires an
encrypted SSL connection.
Sender E-mail Address: Enter an e-mail address that will appear as the
sender for all e-mail notifications sent from the panel.
Recipient E-mail Addresses: Enter one or more e-mail addresses that are to
receive all e-mail notifications from the panel. Use commas to separate
multiple addresses. This field can also be used to send a text message
notification to a phone; see the Text Message Alarm Notifications section
for further information.
SMTP User Name: Enter a SMTP user name here, if required by your SMTP
server. Leave this field blank if the server does not require authentication.
SMTP Password: Enter a SMTP password here, if required by your SMTP
server. Leave this field blank if the server does not require authentication.
Minimum E-mail Interval: Specify a minimum interval required between e-
mail notifications. (Default 1 minute, range 0 to 60 minutes) This time
interval is used to prevent an un-intended flood of e-mail alarm notifications
that could occur when an alarm limit is incorrectly configured, for example.
General E-mail Notifications:
Select these options to receive an e-mail when one or more of these events
occurs.
The Distribution Panel restarts: Check this box to receive an e-mail
notification when the panel restarts after a power failure or a soft reset.
Load-Shedding is activated: Check this box to receive an e-mail notification
when any of the outputs are disabled or enabled due the voltage crossing
one of the load-shed settings configured on the Output Setup page.
The Network Watchdog triggers: Check this box to receive an e-mail
notification after the Network Watchdog triggers due to a loss of the
network connection and the network has comes back online.

Related product manuals