3
Management
3-1. How to wash and clean on a daily basis
Washing the ice maker (daily)
After the ice-making operation, wash the drum surface, material container, drum plate, etc. on a daily basis.
(Failure to do so may cause bacterial growth and bad smell due to the spoilage of the ice-making material.)
u Before performing the cleaning operation, be sure to unplug the power plug from the electrical outlet.
u When washing the ice-maker, do not sprinkle water directly onto the product (except for the drum surface).
u When washing the ice-maker, use clean hands and cloth only.
u Never use abrasive powder, powder detergent, oil, hot water (40℃ or above), rough wire brush, acids, thinner, benzene,
alkaline detergent, etc. Otherwise, the plastic surface may be damaged.
u Before using cleaning agent or fungistatic agent, refer to the precaution on the container label of such products.
u Residual cleaning agent or fungistatic agent may cause adverse effect on health or rusty surface. Completely remove
any residuals of such products.
u Never clean the inside of the machine unless an authorized service technician is required to do so. It is very dangerous
to clean the inside of the machine.
u Never use a rough wire brush, etc. (may cause scratches on the surface of the ice-making plate, material container,
etc., resulting in bad smell, bacterial growth, etc. when the material gets caught within the scratches and goes bad).
u Container designed to receive ice
u Cleaning liquid: Dilute any commercially available neutral detergent with water at a ratio of 1:500 (add 1ℓ of water to
about 2.0㎖ of cleaning liquid)
u Fungistatic agent: Rubbing alcohol in spray container (concentration of 50~80%)
Things to be prepared
① Lift the material
container and remove it.
How to remove the front cover
② Loosen the bolt
securing the front cover
and remove the cover by
pulling it forward.
u Fungistatic agent: Rubbing alcohol in spray container (concentration of 50~80%)
u Fungistatic agent: Sodium hypochlorite solution (concentration of 6%) diluted with water at a ratio of 1:30
(water: 1 liter; solution: about 3.3㎖)
u Brush: Brush with stiff hair is preferred
u Water at room temperature or warm water with temperature of 40℃ or below
u Clean cloth
③ Remove the drum plate by pulling it
down along the diagonal line.
To Next Page
Loading...
General