2
Operation
2-2. How to start the ice-making operation
Open the valve of the cooling water supply pipe connected to
the product.
l Water is supplied to the product.
l Check the cooling water hose connection, etc. for water leak.
Insert the power plug into a properly grounded AC 220V
electrical outlet.
l Before inserting the power plug, install the cooling water supply hose
and drain hose first.
l Put the material into the material container.
Press the power switch.
l When pressing the upper part of the power switch (Ⅰ), the
switch turns ON, and the ice-making operation starts.
switch turns ON, and the ice-making operation starts.
Feed the material by lifting the lever on the material
container.
(Open the lever for about 3 seconds after the power switch is
turned ON to produce good-quality ice in snow form.)
Be sure to feed the material within 10 seconds of turning ON the
power switch.
Ice-making operation lasting for 10 seconds or more without any
material on the drum plate may cause product breakdown.
Open the material lever so that the material can be fed to the
drum plate within 10 seconds of turning ON the power switch.
Material
cut off
Lever
Stop
(middle part of the switch)
Power ON
(upper part of the switch)
Material
feed
Before starting the ice-making operation, be sure to close the front
cover first.
(If the cover remains open during the ice-making operation, hand
injury may occur in case of contact with the drum, or material
contamination may occur.)
drum plate within 10 seconds of turning ON the power switch.
8
To Next Page
Loading...
General