2
Operation
2-3. How to start the ice-making operation
method of safe keeping
Ending the ice-making operation
Press the power switch to turn the power OFF.
l When ice-making is finished after the ice-making material is used up, press
the power switch to stop the operation.
Material
cutoff
Material
feed
Stop the material feeding by lowering the lever on the
material container.
l Lower the lever for two or three seconds before the desired
ice-making quantity is completed.
Stop
(middle part of the switch)
Power ON
(upper part of the switch)
Unplug the power cord from the
electrical outlet.
When not operating the product over an extended period of time
Close the valve on the cooling
water pipe.
Thoroughly wash and clean the material container, material container cover, material container valve, ice-
making drum, drum plate, etc., completely remove any residual moisture, and keep them at a safe place where no
dusts accumulate on the floor.
(middle part of the switch)
(upper part of the switch)
Failure to clean and wash the product parts may cause bad smell and bacterial growth due to the spoilage of
material. Be sure to wash and clean properly.
9
To Next Page
Loading...
General