Need help?Do you have a question about the ICUTTER V12 and is the answer not in the manual?
General| Model | ICUTTER V12 |
|---|---|
| Category | Plotter |
| Interface | USB |
| Connectivity | USB |
| Software Compatibility | Adobe Illustrator, CorelDRAW |
| Power Supply | AC100V~240V /50~60Hz |
Outlines essential safety precautions, warnings, and prohibited actions for operating the cutting plotter.
Identifies and labels the main parts of the cutting plotter visible from the front view of the S-24 model.
Details the process of installing and connecting the cutting plotter to a computer.
Specifies the ideal environmental conditions, dimensions, and placement for setting up the cutter.
Explains how to connect the signal cable (RS232 or USB) between the cutter and the PC.
Guides through the installation process for the USB driver required for computer connection.
Describes the correct procedure for connecting the power cable to the cutting plotter.
Defines the functions of the control panel buttons (Online, Knife Force, Speed, Pause, Test, Repeat) in online mode.
Describes how to navigate and operate the cutter's menus for power display, online/offline modes, and blade movement.
Guides on setting the cutting speed and knife force using specific keys and observing LCD changes.
Explains how to perform the knife drop/raise test by pressing the Test button.
Describes how to perform a test cut operation to check cutting quality and settings.
Explains how to adjust speed and knife force in real-time during operation without pausing.
To Next Page
