Id300 Short-Pulse Laser Source Operating guide
11
5 Warranty
5.1 General information
id Quantique warrants this equipment against defect in material and workmanship for a
period of twelve months from the date of original shipment. id Quantique also warrants
that this equipment will meet applicable specifications under normal use.
During the warranty period, id Quantique will, at its discretion, repair, replace, or issue
credit for any defective product. This warranty also covers recalibration during twelve
months if the equipment is repaired or if the original calibration is erroneous.
Important
The warranty can become void if
the equipment has been tampered with, repaired, or worked upon by
unauthorized individuals or non-id Quantique personnel,
the warranty sticker has been removed,
case screws, other than those specified in this manual, have been
removed,
the case has been opened, other than as explained in this manual,
the equipment serial number has been altered, erased, or removed,
the equipment has been misused, neglected, or damaged by accident.
THIS WARRANTY IS IN LIEU OF ALL OTHER WARRANTIES EXPRESSED,
IMPLIED OR STATUTORY, INCLUDING, BUT NOT LIMITED TO, THE IMPLIED
WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR
PURPOSE. IN NO EVENT SHALL id Quantique BE LIABLE FOR SPECIAL,
INCIDENTAL OR CONSEQUENTIAL DAMAGES.
5.2 Liability
id Quantique shall not be liable for damages resulting from the use of the purchased
product, nor shall be responsible for any failure in the performance of other items to
which the purchased product is connected or the operation of any system of which the
purchased product may be a part.
5.3 Exclusions
id Quantique reserves the right to make changes in the design or construction of any of
its products at any time without incurring any obligation to make changes whatsoever
on units purchased. Accessories, including but not limited to the fuses, pilot lamps and
batteries used with id Quantique's products are not covered by this warranty.
5.4 Certification
id Quantique certifies that this equipment met its published specifications at the time of
shipment from the factory.
To Next Page
Loading...