Id300 Short-Pulse Laser Source Operating guide
9
4.1.2 AC Requirements
The id300 SPLS can operate from any single-phase AC power source between 100 V
and 240 V (50/60 Hz).
4.1.3 Power Cable
This unit uses an international safety standard three-wire power cable. This cable
serves as a ground when connected to an appropriate AC power receptacle. The type
of power cable supplied with each unit is determined according to the country of
destination.
Only qualified electricians should connect a new plug if needed. The colour coding
used in the electric cable depends on the cable. New plugs should meet the local
safety requirements and include the following features:
adequate load-carrying capacity
ground connection
cable clamp
Warning
To avoid electrical shock, do not operate the unit if there are signs of damage to
any part of the outer surface (covers, panels, etc.).
To avoid serious injury, the following precautions must be observed before
powering on the unit.
If the unit is to be powered via an auto-transformer for voltage reduction,
the common terminal must be connected to the grounded power source
pole.
Insert the plug into a power outlet with a protective ground contact. Do
not use an extension cord without a protective conductor.
Before powering on the unit, the protective ground terminal of the unit
must be connected to a protective conductor using the unit power cord.
Do not tamper with the protective ground terminal.
4.2 General Maintenance
There are no user-serviceable components in the id300 SPLS, notwithstanding the
procedure described in this section. The id300 has been designed to require no
maintenance and to provide reliable operation for many years to come.
No service is allowed by customer. The unit is to be returned to the factory for any
service or repair.
Important
When the module is not being used, the protective cap should be fitted over the
detector port.
To help ensure long, trouble-free operation,
Keep the id300 SPLS free of dust
Do not spill liquids on or into the unit. If the unit does get wet, turn off the
power immediately and let the unit dry completely
Clean the id300 SPLS casing with a slightly damp (with water) cloth.
Do not open or modify the unit.
Do not remove protective covers or housings.
To Next Page
Loading...