iDataLink Maestro K150 User Manual (English)

Questions and Answers:

C
cruzmeganSep 8, 2025
Why dash panel of iDataLink Maestro K150 Automobile Accessories K150 lights up, then turns off and climate controls are blowing full heat?
- L
  Laura RogersSep 8, 2025
  If the dash panel of your iDataLink Automobile Accessories K150 lights up and then turns off after a few seconds, and the climate controls are blowing full heat, make sure the cable with 4-pin red connectors plugged to the K150 dash panel is labeled GEN 2. Also, during module programming, ensure you selected K150 as the accessory and not FO2.
M
Mrs. Lisa BeckSep 10, 2025
What to do if iDataLink Automobile Accessories gauges do not work and the radio shows OBD2 Error 1 or Error 2?
- T
  tyler61Sep 10, 2025
  If the gauges aren't working and the radio displays OBD2 Error 1 or Error 2, ensure the 2-pin connectors of the K200 T-harness are configured correctly, as shown in step 2. Also, try resetting the RR.
A
Alison StarkSep 12, 2025
What to do if I cannot hear callers when making a phone call with iDataLink Automobile Accessories?
- T
  tylermillerSep 12, 2025
  If you can't hear callers but they can hear you when making a phone call, and your vehicle has a factory amplifier, ensure that the 4-pin black and white connectors in the harness are plugged in correctly as stated in step 2.
E
Elizabeth MeyersSep 13, 2025
Why is the light on my iDataLink Maestro K150 Maestro flashing RED ONCE?
- L
  Laura BrownSep 13, 2025
  If the light on the Maestro is flashing red once, it indicates that there is no firmware on the module. You should flash the RR module.