IDEAL 4855 - Page 45

- 45 -
A
4.
5.
.
.
.
2.
A
1.
•
Blade and cutting stick replacement
• •
Turn main switch to position "I" (1.). Blade
will return to upper position. Tighten the
blade screws (2.) rmly.
30.
A
4.
5.
1.
3.
2.
.(1.)   
   
(2.)   
   
    
.(3.)   " 0
"
(4.)
  
(A)   
    
.(5.)    
      )
.(
30.
A
4.
5.
1.
3.
2.
.(1.)   
   
(2.)   
   
    
.(3.)   " 0"
(4.)



(A)   
    
.(5.)    
     
)
.(
(B)
31.
2.
A
1.
,(1.) "I"     
   .  
.(
2.
)   5 
32.
Pressung
Messer
OK
OK
!    X
     
!     
.)    (
Close the safety guard (1.) Lower the blade
by pressing both cutting buttons (2.). Keep
one button pressed and turn off the
main switch (3.).
Open the safety guard (4.). With the special
wrench (B) the 3 eccentrics should be
screwed down (5.) until the paper is cut along
the entire length of the blade (the blade
must remain parallel, not too deep into
cutting stick).