POINTS FOR THE BOILER USER
Note. In line with our current warranty policy we would ask that you check
through the following guide to identify any problems external to the boiler prior
to requesting a service engineer visit. Should the problem be found to be other
than with the appliance we reserve the right to levy a charge for the visit, or for
any pre-arranged visit where access is not gained by the engineer.
NO CENTRAL HEATING OR
HOT WATER
Check the mains switch (fused
spur) is turned on and ensure
mode control knob (B)
(Control Panels: P.39) is in the
ON position
Check the Timer is in an
“ON” position, and the room
thermostat is turned up
Does the boiler operate and
provide central heating?
Check the time settings on the
programmer are as you require
and adjust if necessary
NO
YES
See boiler “Operation Modes”
and “Fault Codes” section. If “0”
is displayed then contact a Gas
Safe Registered Engineer or in
IE a Registered Gas Installer
(RGII)
TROUBLESHOOTING.
34
To Next Page
Loading...
Need help?
General