IDEATEC S.A. - Z.I. de Noville-les-Bois - rue Léopold Génicot 19A - 5380 Fernelmont, Belgium - Tel: +32(0)81 42 00 10 - Fax: +32(0)81 57 91 70 - E-mail: info@ideatec.be
User’s guide DLC4000/DLC8000 - Doc. V2.1 - Firmware V3.1
Page 15
Identification des éléments
Description des éléments
Description du produit
11.
&
Page 15
B5
B6
B3
B7
B8
B2 B4
B1
0
1
3
4
3X4X
2
3X
2X
3X
1X
B5
B6
B3
B7
B8
B2 B4
B1
B5
B6
B3
B7
B8
B2 B4
B1
IN 3 +
B5
B6
B3
B7
B8
B2 B4
B1
B5
B6
B3
B7
B8
B2 B4
B1
IN 3 +
4sec.
4sec.
11.5. DLC4000/DLC8000 Configuration - MODE 1
Operation & Configuration (continued)
10.5.1. Key B1 and positive input 3 configuration.
By default the key B1 is a switch and controls the positive output 1. The positive input 3 is an external activator fo the
siren in « switch » mode. It’s possible to disable the key B1 and to put a black pictogram on the key to notify the user of
the console that the key is not available.
When the key is not available then the positive output 1 is a permanent positive output.
Key B1 is by default the Master key for all the functions linked in the B2, B2 or B4 configurations.
The positive input 3 functions are also configured by B1 key in configuration mode 1.
= one pulse on the key
SELECTION FLASHES DESCRIPTION
Key B1 is available and activates the positive output 1.
Key B1 is the Master key by default.
Positive input 3 is an input for blue light status if key B2 is configured as siren mode.
The siren (B2) is goinf is going OFF after 4 seconds if no signal is connected to the
positive input 3.
Key B1 is a momentary push button and activates the positive output 1 when it is
pressed and positive output 1 is OFF when key B1 is released.
Positive input 3 is not used.
Key B1 is a switch and activates the positive output 1.
Key B1 is the Master key by default.
Positive input 3 is not used.
Key B1 is not available and the positive output 1 is a permanent positive output.
Positive input 3 is not used.
Key B1 is available and activates the positive output 1.
Key B1 is the Master key by default.
Positive input 3 is an input for blue light status.
Blue light (B1) is going OFF after 4 seconds if no signal is connected to the positive
input 3.
To Next Page
Loading...
