IDEATEC DLC8000 - Output

IDEATEC S.A. - Z.I. de Noville-les-Bois - rue Léopold Génicot 19A - 5380 Fernelmont, Belgium - Tel: +32(0)81 42 00 10 - Fax: +32(0)81 57 91 70 - E-mail: info@ideatec.be
User’s guide DLC4000/DLC8000 - Doc. V2.1 - Firmware V3.1
Page 16
Identification des éléments
Description des éléments
Description du produit
11.
&
Page 15
5
7
8
3X8X
6
3X
6X
7X
5X
B5
B6
B3
B7
B8
B2 B4
B1
B5
B6
B3
B7
B8
B2 B4
B1
IN 3 +
B5
B6
B3
B7
B8
B2 B4
B1
IN 3 +
B5
B6
B3
B7
B8
B2 B4
B1
B5
B6
B3
B7
B8
B2 B4
B1
IN 3 +
B5
B6
B3
B7
B8
B2 B4
B1
IN 3 +
B5
B6
B3
B7
B8
B2 B4
B1
B5
B6
B3
B7
B8
B2 B4
B1
IN 3 +
B5
B6
B3
B7
B8
B2 B4
B1
IN 3 +
B5
B6
B3
B7
B8
B2 B4
B1
B5
B6
B3
B7
B8
B2 B4
B1
IN 3 +
B5
B6
B3
B7
B8
B2 B4
B1
IN 3 +
Operation & Configuration (continued)
11.5. DLC4000/DLC8000 Configuration - MODE 1 (continued)
10.5.1. Key B1 and positive input 3 configuration (continued).
SELECTION FLASHES DESCRIPTION
Key B1 is a switch and activates the positive output 1.
Key B1 is the Master key by default.
Positive input 3 is a external activator in switch mode if the key B2 is configured in
siren mode.
The siren is working until the signal on input 3 is active (siren can always be activated or
disabled by the key B2).
Key B1 is a switch and activates the positive output 1.
Key B1 is the Master key by default.
Positive input 3 is a external activator in switch mode if the key B2 is configured in
siren mode and the key B1 « blue light » is already activated.
The siren is working until the signal on input 3 is active (siren can always be activated or
disabled by the key B2).
Key B1 is a switch and activates the positive output 1.
Key B1 is the Master key by default.
Positive input 3 is a external activator in pulse mode if the key B2 is configured in
siren mode and the key B1 « blue light » is already activated.
First pulse on input 3 = siren start, second pulse = siren stop (siren can always be
activated or disabled by the key B2).
1st pulse
2nd pulse
1st pulse
2nd pulse
Key B1 is a switch and activates the positive output 1.
Key B1 is the Master key by default.
Positive input 3 is a external activator in pulse mode if the key B2 is configured in
siren mode.
First pulse on input 3 = siren start, second pulse = siren stop (siren can always be
activated or disabled by the key B2).