iDect Eclipse Plus - Change the Recall Time

65
10.6
10.610.6
10.6 Change
ChangeChange
Change the
thethe
the R
RR
Recall
ecall ecall
ecall T
TT
Time
imeime
ime
You may need to press T (main Eclipse handset) or F (additional
handsets) to send a Flash signal (also called Recall or Timed Break Recall)
if you are connected to a PBX or using certain network services. You
should normally leave the Recall Time at its default setting, Short
Short Short
Short
(100ms)
(100ms)(100ms)
(100ms), as this is the standard recall required in the UK telephone
network. However, it can be changed to Medium (270ms) or Long
(600ms) if your telephone is connected to a PBX that requires a different
recall time.
- On Your
On YourOn Your
On Your Main
MainMain
Main Eclipse Handse
Eclipse HandseEclipse Handse
Eclipse Handset
tt
t
1. From the home screen, press
M.
2. Press
+/- to SETTINGS
SETTINGSSETTINGS
SETTINGS and then press M to select.
3. Press
+/-to RECALL TIME
RECALL TIMERECALL TIME
RECALL TIME and then press M to select.
4. Press
+/- to select SHORT
SHORTSHORT
SHORT, MEDIUM
MEDIUMMEDIUM
MEDIUM or LONG
LONGLONG
LONG and then
press M to confirm.
• A confirmation tone is played.
5. Press O to return to standby mode.
- On Your Additional Handset
On Your Additional HandsetOn Your Additional Handset
On Your Additional Handset
1. From the home screen, press M .
2. Press
+\- to ADVANCED SET
ADVANCED SETADVANCED SET
ADVANCED SET and then press M to select.
3. Press
+\- to RECALL TIME
RECALL TIMERECALL TIME
RECALL TIME and then press M (additional
handsets) to select.
4. Press
+\- to select SHORT
SHORTSHORT
SHORT, MEDIUM
MEDIUMMEDIUM
MEDIUM or LONG
LONGLONG
LONG and then
press M to confirm.
• A confirmation tone is played.
5. Press O to return to standby mode.