1.0 Introduction
This document details the Physical Access Control Reader uTrust TS Contact Keypad Reader and
its basic user instruction and installation procedures.
The 8216 reader extends the features supported by the 8210 readers, by adding interfaces for
accessing a Contact Smart Card and a SAM interface. The contact interface enables users to
securely access their contact smart cards with or without the use of a Keypad pin. The addition of a
SAM interface enables end users to load a SAM module for enhanced/ secure card read operations
and support for third party proprietary protocols.
The reader supports Wiegand and RS485 (OSDP protocol) interfaces for communications to the
control panel.
2.0 Reader
2.1 Functionality
8216 is a physical access control smart card reader (accessory equipment) that can read the following
credentials
Contactless HF (13.56MHz) conforming with ISO 14443 A & B, ISO15693
Contactless LF (125KHz) credentials of type FSK, ASK, PSK
Contact Smartcards – conforming to ISO-7816 in the ID-1 formfactor
Keypad interface - can be used stand-alone or, for high secure applications, it adds a second
level of authentication with a user PIN.
User-feedback interfaces on the reader include RGB LED’s and Buzzer.
The reader can be interfaced with an access control panel equipped with a Wiegand or an
RS485 half-duplex interface
2.2 Front/Top Casing
To Next Page
Loading...
