4
DOC No: 8540 REV E
5
DOC No: 8540 REV E
The following are used throughout this guide to indicate procedure that, if not followed
correctly, may result in injury to personnel or damage to equipment.
Warnings are used to alert the reader to a procedure or practice, which if
not followed correctly, could result in personal injury.
Limits of Use 6
Installation in Explosive and Fire Danger Zones 7
Description 7
Function 7
Unpacking and Storage 8
Assembly 8
Space Requirements 8
Location 9
Bulkhead Mounting 9
EMC Compatibility 9
Electrical Connection 10
Lead Assignments 12
Operation 13
Manual Control Adjustment 14
Magnet Decoupling 15
Maintenance 15
Fault Isolation 16
Technical Specifi cation 17-19
Notes 20-22
Table of Contents
CAUTION
NOTE
represents years of fl uid handling experience and we feel it is the fi nest product available
of its type.
The product you have purchased was designed and constructed for use within designated
limits and conditions. Staying within performance limits and following the guidelines given
in this manual will result in excellent performance and maximum life.
Should you have a question or a problem, technical assistance is available worldwide.
Micropump products are designed for easy fi eld servicing with service kits and technical
support available for all products.
The Purpose of this Guide...
is to provide information to enable suitably qualifi ed technicians and fi tters to install,
operate and maintain the Micropump EagleDrive and common pump/motor combinations.
Use the Guide...
when you have purchased a motor or pump/motor combination. This guide contains
specifi c information for installation, operation, and maintenance of the EagleDrive and
references some of the most common pump/motor combinations. This guide should
be read in conjunction with the instructions provided with your specifi c pump. General
information is given on installation within a system, but reference should always be made
to instructions provided with ancillary equipment when installing the unit.
Abbreviations
The following abbreviations are used in this guide:
°C Degrees Celsius °F Degrees Fahrenheit
EMC Electromagnetic Compliance DC Direct Current
LVD Low Voltage Directive
IOM Installation, Operation and Maintenance Manual
Max Maximum Min Minimum
RPM Revolutions Per Minute SELV Safety Electric Low Voltage
V Volt(s) W Watt(s)
Warning - Hot Surface is used to alert the reader to a procedure or
practice, which if not followed correctly, could result in personal injury
due to contact with a hot surface.
Cautions are used to alert the reader to a procedure or practice, which
if not followed correctly, could result in damage to the pump, motor, or
ancillary equipment.
Notes are used to highlight important information that may assist the reader in
carrying out a procedure or in understanding the text.
Safety
Your Micropump Product...
To Next Page
Loading...
Need help?
General
