EasyManua.ls Logo

IDFTECH Poseidon Pro V2 - Landing Procedure; Descent and Landing; Motor Disarming

Default Icon
28 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
@2020 iDFTECH
20
The craft will descend when the left throttle stick is below halfway
Gradually and slowly reduce height
Always slow the drone down to eye level before landing the craft gently
On touch down or at a height of 10 centimetres above the ground level, disarm the motors by either holding
both sticks down and inwards, or down and outwards and try to make sure that both sticks are moved at the
same time – Always hold the sticks down until the motors completely stop.
Landing The Craft
Always commit to a motor disarm – That is, if you have commenced motor dis-arming never abort the disarm –
You must commit to disarm no matter what happens. Incidents occur such as - You have committed to a motor disarm
and a gust of wind moves the drone – Commit to Disarm as failure to do this could result in damage to the motors and or
propellers.
Once the drone has landed and the motors have completely stopped, turn the drone off and then turn off the
remote control in this sequence.
Always fly in GPS mode - SWB switch in the top position
Never Dis-Arm the craft whilst in the air – Unless a collision is un-avoidable. By disarming the propellers
before a collision may save the Motors from damage.