@2020 iDFTECH
11
Starting and Stopping Motors
Pushing the throttle directly does not start the motor. You rst need to turn the control mode switch (SWB) to
the attitude mode position, keep the drone stationary for 7 seconds and then start or stop the motor according
to any one of the following four images below.
1. In the attitude mode/GPS mode, if the throttle is not pushed to move more than 10% after starting the
motor, the remote controller will automatically enter the landing mode and will automatically stop after
about 3 seconds.
2. Execute the above action to stop the motor and power off the aircraft
Never attempt the above actions while quadcopter is in flight.
LiPo Voltage Chart
20.00%
30.00%
40.00%
50.00%
60.00%
70.00%
80.00%
90.00%
100.00%
1 Cell 2 Cell 3 Cell 4 Cell 5 Cell 6 Cell
3.72
3.78
3.84
3.90
3.94
4.02
4.08
4.14
4.20
7.44
7.56
7.68
7.80
7.92
8.04
8.16
8.28
8.40
11.36
11.34
11.52
11.70
11.88
12.06
12.24
12.42
12.60
14.88
15.12
15.36
15.60
15.84
16.08
16.32
16.56
16.80
18.60
18.90
19.20
19.50
19.80
20.10
20.40
20.70
21.00
22.32
22.68
23.04
23.40
23.76
24.12
24.48
24.84
25.20
Selecting Flight Modes
1. GPS mode (the SWB switch in the top position)
a. Always select areas without high-rise building and stay away from strong magnetic environments such as
car parks and power poles
b. Turn the remote control on and then the drone
c. Select the (SWB) switch to the top position
d. The LED red light flashes into the search star status and wait for the LED red light to flash 6 times. When
the red light stops flashing the GPS is enabled and successfully positioned
e. In this mode the aricraft will hold position in hover mode when joysticks are returned to central position
When flying in GPS mode, should you nd that the aircraft is flying unstably or uncontrollably, please switch the flight mode to
attitude mode to regain full control of the aircraft to avoid accidents. Return aircraft and re calibrate compass.
To Next Page
Loading...