EasyManua.ls Logo

IDW G-10F - Door Reversal (For G-10 f Coolers Only)

IDW G-10F
20 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Innovative DisplayWorks
G-10f/GCG-10f
CONDENSER MAINTENANCE
It is essential to keep the condenser coils clean and free of dust and debris at all
times.Itisrequiredtoperiodicallycleanthecondensercoilswithasoftbristlebrush
or vacuum-cleaner to properly maintain the refrigeration system. Failure to clean
the condenser at regular intervals may cause failure of the refrigeration system and
couldvoidthewarranty.
1 Remove the rubber cap from the front grill.
2UsingaPhillipsscrewdriver,removethethreescrewsas
shown.
3Thefrontplasticgrillcannowberemovedbypullingitup.
4Usingplasticbristlebrush,carefullycleanthecoilbeingawarethatnscanbendorbe
damagediftoomuchforceisused-shownleft.
5ReplacegrillandutilizethePhillipsscrewdrivertotightenthescrewsintoplace,replacetherubbercaps.
MAINTENANCE - Cleaning Shutdown Questions and Answers
Cleaning and Maintenance
1 Unplug the cooler before cleaning.
2 Useasoftclothorspongewithwaterorsoap(non-corrosivemilddetergent),whilecleaning.
Aftercleaning,wipethecoolerusingdryclothtokeepthecoolerfromrusting.
3 Donotspraywateronthecooler,anddonotusehardorsteelbrushestocleanthecooler.
4 Donotuseorganicsolvents,boilingwater,washingpowderoracidwhilecleaning.
5. Adrainorwasteoutletmaybeprovidedforthedrainingofadisplayrefrigerator.Ifthedisplay
refrigeratordrainsareprovidedforushing,theyshallhaveaminimuminternaldiameterof1˝(25mm).
Ifthecooler’spowerwillbeoffforalongperiodoftime,unplugit,cleanasinstructedabove,andkeepdoor
open until dry.
10

Related product manuals