5EN
/
Main unit (NVR) Front
Panel
Main unit (NVR) Rear
Panel
/
/
04
05
③ ② ①
①
Power lamp Lights red when the power is on.
②
Recording lamp Lights up when recording.
③
Warning lamp
If settings such as motion
detection are made, this lights
up when motion is detected.
①
power switch Turn the power 0N/OFF.
②
PoE LAN
Connect the point camera with
a LAN cable.
③
Audio output
terminal
Connect the audio terminal
of the beaker (please prepare
separately).
* Connect to the monitor using
an HDMI cable.
Not required if you have
④
Video output
terminal (VGA)
Connect to the monitor using
a VGA cable (please prepare
separately).
* Connect to the monitor using
an HDMI cable.
Not required if you have
⑤
Video output
terminal (HDMI)
Connect to the monitor using
an HDMI cable (please prepare
separately).
① ② ③ ④ ⑤ ⑥ ⑦
To Next Page
Loading...