17EN
/
③
Camera Settings
Click Settings > Camera Settings to enter the interface.
You can select camera channel or bitrate of main stream,
as well as set up motion detection , sound detection , light or
audible alarm function (Some channels support functions
such as sound detection , sound and light alarm . Please
select the channel according to the actual situation.)
1. set up camera: You can select camera channel, set up
bitrate of main stream and select video encoding format.
(Note:supports 8 channels (8 cameras) simultaneous
monitoring and recording.)
2. Motion detection: Steps to set up motion detection: "Settings"
> "Channel Settings" > "Motion Detection" > "Enable" (Note:
"Motion Detection" is turned on at the factory. Sensitivity is
medium. Sensitivity is adjustable. )
①
Enable: Turn on/off motion detection.
②
Sensitivity: The detection sensitivity can be adjusted to [low,
medium, high]. The detection distance of motion detection
varies depending on the sensitivity setting.
③
Defense time: Set the time when the alarm can be detected.
④
Alarm method: turn on/off the detection notication
function, turn on/off the detection recording function
⑤
Set the detection area: Use the selection stick to specify
the area (the yellow selection shown in the preview is the
detection area). After selecting the area, click "Apply". The
setup is complete. Only detect movement within the area
after a set time Do it.
To Next Page
Loading...