05
8.USB Charging Icon
When USB is connected and generated exceed 100 mA current, the USB icon lights up.
The icon flashing indicates intermittent charging or the load current exceeds 500mA, at this time
it will automatically turn on the protection mode.
9. Parameter Setting and Definition
P02: Mileage Unit, 0: Km; 1: Mile;
P04: Sleep Time, 0: no sleep; Other Numbers: sleep time; Range, 1-60 minute;
P09: Zero Start, Non-zero Start, 0: zero start; 1: non-zero start;
P16: Real-time Cruise: 1: with this function; 0: without this function;
P99: One-key Reset, (long press the MODE button for 5-6 seconds, all parameters are reset to
the initial settings of the first start)
ODO: ODO Reset (short press the MODE button and then long press for 5-6 seconds until the
number is zero)
Brief Introduction Of Key Functions
2.1 Long press the power button to power on, and then short press the power button, the
interface will switch between ODO, TRIP, V, A, E, TM.
2.2 Long press the power button to power off.
2.3 Long press the M button and the power button to enter the mode setting. In the setting
interface, short press the power button to switch parameters.
Short press the M button to change the speed, the gear shifts from 0 to the highest gear cyclical-
ly. (The gears default to 3 gears, 0 gear motor will not run, 3 gears is highest speed.)
Parameter Modification:
Long press the power button and M button to enter the parameter setting, the same way to exit
the parameter setting. The parameter modification will be completed after power off and restart.
2.4 Adjust the accelerator to speed up; Release it to return to the zero position.
2.5 The headlight switch button controls the headlights and rear taillights, long press the M
button for 3 seconds to control the side lights of the pedal.
To Next Page
Loading...
