IFB Digital - Spin Select; Start;Pause

12
SPIN SELECT
When Spin Select button is pressed, default speed will be shown on the display along with
the “ ” symbol. Spin speed selection sequence will be Default speed (DS ) DS-
100rpm DS - 200rpm....... 400rpm > No final Spin ( 0 rpm ) Rinse Hold
Default Speed ...
To select ‘No final spin’, press the Spin Select button till the value ‘0’ is shown on the
Display.
When ‘No final spin’ is selected, the machine will not spin during final spinning operation.
Spin speeds between 400 rpm to 900-rpm max. can be selected by pressing the button.
The maximum spin speeds are automatically limited to the following for better fabric care.
Program Maximum spin speed (rpm)
Cotton, Eco, Quick Wash, Heavy load 900
Synthetic, Mix 800
Delicates, Wool, Saree 600
l
l
l
l
l
l
l
l
l
l
l
l
l
l
l
è
è è
è è
Rinse Hold
Rinse hold option will prevent clothes from creasing by holding them in water before
final spin.
During the Rinse hold stage, the Spin Select button LED will flash & the program can be
continued further to either drain out the water or spin the clothes.
To do this, Set the Spin Select button to ‘0’ or desired spin speed è Press Start
In addition to “Rinse Hold” option, an inbuilt anti-crease action of tumbling takes place
after final spin to reduce creasing.
START/PAUSE
After choosing the desired program and options press this button to start the program. Keep
Start/ Pause button pressed for 1 second to enter pause state.
To change the program during the machine run, Press Pause button è Switch OFF the
machine è Switch ON è Select a new program.
To select / deselect the options during the program run, Press Pause button è Change the
options è Press Start button.
Pause mode is indicated by the simultaneous flashing of “Clock symbol” and balance
time on the display.
INBUILT ANTICREASE
In order to reduce the wrinkles on the laundry after final spin cycle, the machine is provided
with an ‘Inbuilt Anticrease’ feature.
Subsequent fluffing of the clothes will be done thereby it helps you to unload the laundry
from the drum with ease!
NOTE:
1. To open the door during program run, pause the machine and the door will get
opened after a delay of 1 - 2 minutes.
2. To prevent any untoward incidents to you, additional protection is provided in
which the door cannot be opened even if paused when the water temperature in the
0
drum is above 50 C or if the water level inside the drum is high or if the washing
machine is in spinning operation.
Spin
Select
Start
Pause