IFB Digital - Check Points; Programming the Machine; Switching Off the Machine

20
CHECK POINTS:
Before switching your machine ‘ON’ check if …..
The power supply plug is connected to a 230 V, 50 Hz supply with proper earthing.
The water inlet stopcock is fully open.
The inlet and exhaust hoses are straight and free from twist.
The coin trap is closed firmly and exhaust pipe is connected to drain.
PROGRAMMING THE MACHINE:
1. Switch ON the mains supply.
2. Rotate the programmer knob to the desired program.
3. Set the final spin speed required.
4. Select the options preferred for the chosen program from the flashing options. After selection, the indicator light of
the chosen options will glow.
The chosen options can be deselected by pressing the button again.
Non-flashing options indicate that they are not applicable for the corresponding program.
5. Open the door and load the clothes inside the drum.
6. Put the detergent in the respective chamber.
7. Press the “Start/Pause” button to start the washing cycle. Flashing of optional button indicator lights will turn OFF.
8. If required enable the ‘Child lock’ feature to prevent any tampering of program.
9. To change the options, Pause the machine Select / Deselect the options Press Start button. The machine will
acknowledge the changes done automatically.
10. To change / cancel the program during the machine run, Press Pause button è Switch OFF the machine èSwitch
ON è Select a new program
11. Washing, Soaking, Rinsing & Spinning can be seen through the porthole door.
12. The time remaining to complete the washing cycle can be seen on digital display at any time during washing.
SWITCHING OFF THE MACHINE:
At the end of the program “End” message will be shown on the digital display.
Open the door by pulling the door handle to remove the clothes from the machine
Switch OFF the machine by rotating the program selector knob to “OFF” position.
Leave door slightly ajar to dry out the inside of the machine
l
l
l
l
l
l
l
è è