EasyManua.ls Logo

IFB Digital - Trouble Shooting; Common Issues

IFB Digital
28 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
23
WHY DOES IT HAPPEN ?
DIGITAL DISPLAY DOES NOT GLOW
Check if the machine is ON.
Check for loose connections in plug/socket
Check if the programmer selector knob is in OFF position.
WASHING MACHINE DOOR DOES NOT OPEN
For reasons of safety, the washing machine door cannot be opened when the water level, temperature or the speed is too
high
MACHINE DOES NOT START
Check if machine is powered ON.
Check if the “Start/Pause” button is ON . The symbol will blink when it is pressed.
Check water supply.
Porthole door not closed properly.
WATER DOES NOT ENTER MACHINE/DETERGENT NOT BEING FLUSHED INTO DRUM
Check water supply
Porthole door not firmly closed
Water tap not turned on
Bent inlet hose
Sieve on inlet valve/ inlet hose clogged.
SUDS ESCAPING FROM DETERGENT DISPENSER TRAY
Detergent used is not a washing machine detergent
Excessive detergent used
WATER LEAKAGE FROM THE MACHINE
Inlet/Outlet hose connection loose
Coin trap not screwed on properly
Inlet hose leaking
MACHINE DOES NOT DRAIN
Coin trap clogged
Outlet hose end above 1 meter. from floor level
MACHINE DOES NOT SPIN / CLOTHES REMAIN WET
Check if the Spin speed is set to “0” rpm
Rinse Hold option is selected
Coin trap is clogged.
Unblanced load ( Divide the load in two halfs and spin each load using exclusive spin program with desired spin
speed or add smaller articles of laundry to balance the load & repeat the spin cycle.)
Excessive detergent / Foam
Load is too small.
MACHINE VIBRATES MORE DURING SPINNING
Machine not levelled properly
Coin trap clogged partially.
Clothes not loaded as instructed
MOTOR NOISE
It is normal for noises to be heard while motor is running. However wash load, belt tension and motor mounting bolt should be
checked for specified limits.
PUMP NOISE
It is normal for noises to be heard from the pump during the start-up and final stage of draining. However check for fluff
filter clogging.
PROGRAM CYCLE TIME DELAYED/ BALANCE TIME ON THE DISPLAY REMAINS STATIONARY
Not a fault
It is normal as the washing time may vary depending upon the type and quantity of laundry, inlet water pressure, inlet
water temperature, variations in power supply and other usage conditions.
Check if the program is active.
/ EXCESSIVE FOAM IN THE
DRUM.

Other manuals for IFB Digital

Related product manuals