IFB Digital - Error Interpretation

24
ERROR INTERPRETATION
Check the following before asking if the error message is displayed during the programme run:-
ERROR
MESSAGE POSSIBLE CAUSE SOLUTION
Door is not closed properly Open and then close the door properly
Water tap turned off Turn the water tap ON.
Water supply not available Machine will start automatically on
resumption of water supply.
Sieve / filter blocked in water inlet hose. Clean Sieve/Filter (Refer Page 21 for details )
Water pressure too low Eliminate Cause.
Bent/damaged Water inlet hose Remove bend / damage
Overloading of washing machine The washer restarts after about 30 min.
Programme time is extended due to low inlet
water temperature / low input voltage.
Coin trap is blocked. Switch OFF the appliance. Select & Run Drain
program till water is totally drained out from
the machine. Clean Coin trap (Refer page 21
for details)
Exhaust hose clogged/bent Clean the exhaust hose / Remove bend.
Motor control function interrupted Please call service personnel
If the error message could not be solved with the aid of the above table:
*Switch OFF the appliance. è * Wait for 15 seconds. è *Switch ON the appliance. è *Select and start a cold
wash program
If the error message repeats, please call service personnel.
E:07