9
Bluetooth pairing
When the Bluetooth input is selected, the Bluetooth icon in the display will repeatedly blink twice
and search for a previously paired device. If a stored device is not found, it will automatically enter
pairing mode and ash.
Press and hold the button (1s) to enter pairing mode until the Bluetooth icon ashes. To pair, nd
the 'iFi Lossless Audio' Bluetooth device on your audio source device such as a mobile phone.
The NEO iDSD 2 can store up to 8 paired Bluetooth devices. To delete all previously stored devices,
please perform a factory reset (item 2 - VII).
6. Gain selection
Short press cycles through these four gain modes:
> > >
iEMatch Normal Turbo Nitro
-12dB 0dB +8dB +16dB
Note: Always start from 0dB and then increase the gain level to attain an enjoyable and comfortable level of volume from the headphones.
Warning: At the outset do not use excessive gain, otherwise damage to hearing or connected headphones may ensue. AMR/iFi audio is not
responsible for any damage/injury from misuse.
To Next Page
Loading...
