10
7. XBass II selection
Cycle through the three bass modes to select:
XBass II is an analogue circuit designed to 'add back' the lost bass response for more accurate
reproduction of the original music.
Note: Research into headphone frequency response showed that a purely at response may not be correct. Our long present XBass ts the prole
of the low-frequency correction required. However, it was also shown that a certain amount of upper midrange boost is needed to give many
headphones a more 'natural' sound.
This upper midrange region is usually called the 'presence' region; we have used this term to indicate the upper midrange correction. In the NEO
iDSD2, XBass II (or perhaps better HPEQ) can be selected to have either Bass + Presence correction,only Bass or only Presence correction.
Note: Sonically-hindering DSP is NOT used for XBass II nor XSpace matrix systems. They use the highest-quality discrete components and operate
purely in the analogue domain. Hence all the clarity and resolution of the original music is retained.
8. Balanced 4.4mm headphone output
Connect balanced 4.4mm headphones.
9. Unbalanced 6.3mm headphone output
Connection for 6.3 single ended headphones . Please use 3.5 to 6.3 mm adaptor for 3.5 single
ended headphones.
O
O XBass Presence XBass + Presence
>> >
To Next Page
Loading...
