ifi SMX100 - Request Amplifier Status (Power and Metering)

Page
30
REQUEST AMPLIFIER STATUS
(POWER AND METERING)
CODE AMPLIFIER FUNCTION
POWERFWD
Returns Forward Power Value
POWERRFL
Returns Reflected Power Value
PS1V
Returns Power Supply 1 Volts Value
PS1I
Returns Power Supply 1 Current Value
PS2V
Returns Power Supply 2 Volts Value [when applicable]
PS2I
Returns Power Supply 2 Current Value [when applicable]
TOTALH
Returns Filament Hours Value
OPERATEH
Returns Beam Hours Value
BAND1
Selects Band 1 of Operation [ In Dual Band units only ]
BAND2
Selects Band 2 of Operation [ In Dual Band units only ]
NOLEV
Selects NO Leveling [ Optional ]
INTLEV
Selects INTERNAL Leveling [ Optional ]
EXTLEV
Selects EXTERNAL Leveling [ Optional ]
ZEROATT
Sets the Amplifier for ZERO Attenuation
FULLATT
Sets the Amplifier for FULL Attenuation
GAIN
Returns Gain Value in percentage
*IDN?
Returns ASCII response comprising of four data fields in the format
<Manufacturer>, <Model>, <Serial Number>, <Firmware Version>
*RST
Reset Command, Sets the Amplifier to the factory default power up state
NOTES:
1. ALL GPIB COMMANDS AND REQUESTS MUST CONSIST ENTIRELY OF UPPER CASE
ALPHANUMERIC CHARACTERS.
2. WHEN SENDING COMMAND STRINGS TO THE AMPLIFIER, A CARRIAGE RETURN
CHARACTER (0Dh) FOLLOWED BY A LINE FEED CHARACTER (0Ah), MUST ALWAYS BE
APPENDED TO THE COMMAND, and OTHERWISE THE AMPLIFIER WILL WAIT
INDEFINITELY FOR THE CR-LF COMBINATION.