Page
14
4.5 OPERATING INSTRUCTIONS
4.5.1 Power On
FIGURE 3.0 – FRONT PANEL DISPLAY (START-UP MENU)
Apply power to the unit using the front panel ON/OFF switch. When the circuit breaker or AC
Power On switch is energized, the above menu will be displayed after the Microprocessor (MPU)
booting cycle has completed. This menu displays the company information, the amplifier model
number and serial number along with the firmware version used. The Start-Up menu will be
replaced by the Operate Menu after about 5 seconds or the operator my elect to bypass the Start-Up
Menu by pressing the CONT button.
From this menu, the GPIB ADDRESS (GPIB ADDR) Number can be entered.
To Next Page
Loading...
