Page
8
SECTION 4.0
GENERAL INFORMATION
4.1 SCOPE OF THIS MANUAL
This manual is intended to inform a qualified transmitter operator or technician of the normal
operating and maintenance procedures for the SMX100. It is not intended to be a course of
instruction for unqualified personnel.
4.2 GENERAL SPECIFICATIONS
The specifications listed below represent the minimum performance characteristics at the time of
delivery.
SPECIFICATIONS
Frequency Response:
Band One: 10 kHz - 220 MHz
Band Two: 200 MHz - 1000 MHz
Power Output: Minimum 100 Watts
AC Source: 115 VAC, 50/60 Hz, Single Phase
Power Gain: 50 dB
Input Impedance: Nominal 50 Ohms unbalanced
Output Impedance: Nominal 50 Ohms unbalanced
Input Signal Levels: < 0 dBm ( 1.0 mW ) See data sheet for specific input drive levels
Harmonic Distortion: -20dBc @ 60W
Duty Cycle: CW
Spurious: -50dBc
To Next Page
Loading...
