Need help?Do you have a question about the IFM Electronic efector 300 SI5004 and is the answer not in the manual?
General| Type | Inductive sensor |
|---|---|
| Product group | Sensors |
| Manufacturer | IFM Electronic |
| Model | SI5004 |
| Series | efector 300 |
| Operating voltage [V] | 10-30 V DC |
| Current consumption [mA] | ≤ 15 mA |
| Protection class | IP67 |
| Ambient temperature [°C] | -25 to +70 |
| Protection Rating | IP67 |
| Connection technology | M12 connector |
| Housing materials | Plastic |
| Operating Temperature | -25 to +70 °C |
The unit monitors the flow of liquid media.
Explains the calorimetric principle for flow detection and analog output signal (4-20 mA).
Details general, recommended, and conditional installation positions for optimal sensor performance.
Advises on distances from pipe components to avoid turbulence and ensure correct function.
Provides step-by-step instructions for mounting the unit, including greasing and tightening torque.
Explains how to adapt the unit to higher flow conditions by adjusting the display representation.
Details how to adapt the unit for minimum flow when used with media other than water.
Provides instructions on how to reset all settings back to the original factory configuration.
Explains how to electronically lock or unlock the unit to prevent unintentional setting changes.
To Next Page