Need help?Do you have a question about the IFM Electronic Efector 300 and is the answer not in the manual?
General| Product group | Accessories |
|---|---|
| Manufacturer | IFM Electronic |
| Series | Efector |
| Operating Temperature | -20°C to +70°C |
| Protection Rating | IP67 |
Explains the magnetic-inductive principle using coils, electrodes, and charge carriers to measure flow velocity.
Describes how the unit displays process values and generates two output signals (analogue/IO-Link for flow, analogue for temperature).
Details the analogue output for volumetric flow and detection of flow direction, with options to invert it.
Explains how the unit detects an empty pipe via electrodes and indicates it, with options for time-dependency.
Provides guidance and an example for optimal installation, emphasizing full pipe and compensation for disturbances.
Lists specific locations to avoid for installation, such as falling pipes, pump suction sides, and pipe system high points.
Details the process of installing the unit in pipes using adapters, including steps and corrective measures for air bubbles.
Details the 'CFG' menu for basic settings, showing parameters like FOU1, FOU2, dAP, diS, Uni.F, Uni.T, SELd, LFC, Fdir.
Provides a step-by-step guide on how to select, change, and confirm parameter values using the device's buttons.
Guides on setting the analogue start point (ASP1) and end point (AEP1) for volumetric flow.
Guides on setting the analogue start point (ASP2) and end point (AEP2) for temperature.
Guides on resetting all parameters to their factory default values.
Explains how to read the currently displayed process value using LEDs and the display, including selecting different values.
Details the steps to display a currently set parameter value, including how the display cycles through parameter and value.
Lists warning messages like [OL], [UL], [Err], [C.Loc], [S.Loc], [SEnS], [IOE.n] and their meanings.
To Next Page