Igel UD7 - UD2 (M250 C); UD2 (D220); UD9 (TC215 B)

IGEL Devices
Boot Settings
4/5
3.
4.
5.
6.
7.
8.
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
1.
2.
3.
4.
5.
Select theBoottab.
SetUSB Bootto<ENABLED>.
SelectLegacy > Boot Type Order.
SelectUSBand move it to the first position using the [+]key.
Save the settings and exit.
You can continue with theinstallation procedure.
UD2 (M250C)
Power up the device while pressing [Del] button repeatedly in rapid succession.
SelectSCU.
If a password prompt is shown, enter the BIOS password.
Select theBoottab.
SetUSB Bootto<ENABLED>.
Save the settings and exit.
Connect the USB stick to the device.
Reboot the device while pressing the [Del] button repeatedly in rapid succession.
SelectBoot Manager.
Select the USB stick as the boot medium and pressEnter.
You can continue with theinstallation procedure.
UD2 (D220)
Power up the device while pressing the [F2] (older devices) or[Del](newer devices) button
repeatedly in rapid succession.
SelectSCU.
If a password prompt is shown, enter the BIOS password.
Select theBoottab.
SetUSB Bootto<ENABLED>.
Save the settings and exit.
Connect the USB stick to the device.
Reboot the device while pressing the [F2]or[Del](newer devices) button repeatedly in rapid
succession.
SelectBoot Manager.
Select the USB stick as the boot medium and pressEnter.
You can continue with theinstallation procedure.
UD9 (TC215B)
Power up the device while pressing the [F2]button repeatedly in rapid succession.
If a password prompt is shown, enter the BIOS password.
Select theBoottab.
SelectBoot Option Priorities.
Select the entry for the USB stick and move it to the first position using the [+]key.