9
COUNTERTOP INSTALLATION
Remove all packing material and accessories. Examine the microwave for any
damage such as dents or a broken door. Do not install if microwave is damaged.
Cabinet: Remove any protective lm found on the microwave cabinet surface.
Do not remove the light brown Mica cover that is attached to the microwave
cavity to protect the magnetron.
INSTALLATION
1. Select a level surface that provides enough open space for the intake and/or
outlet vents.
(1) The minimum installation height is 85cm.
(2) The rear surface of the appliance should be placed against a wall. Leave a
minimum clearance of 30cm above the microwave, a minimum clearance of
20cm is required between the microwave and any adjacent walls.
(3) Do not remove the legs from the bottom of the microwave.
(4) Blocking the intake and/or outlet openings can damage the microwave.
(5) Place the microwave as far away from radios and TV as possible.
Operation of the microwave may cause interference to your radio or TV
reception.
2. Plug your microwave into a standard household outlet. Be sure the voltage and
the frequency is the same as the voltage and the frequency on the rating label.
WARNING: Do not install microwave over a range cooktop or other heat-
producing appliances. If installed near or over a heat source, the microwave could
be damaged and the warranty would be void.
The accessible surface may be hot during operation.
To Next Page
Loading...
