Igloo CURP3 - Maintenance

REFRIGERATION LTD
12
www.igloorefrigeration.com | Pastry Display Cases
H5
ID code (read-only)
0
-
1
+199
EZY
restore the Default settings
0
0
1
5. MAINTENANCE
• Before you start Maintenance on the unit, Power it OFF.
• Do not use steel wool, abrasive cleaners, bleach or cleaners containing chlorine or sodium to clean the unit.
• Do not use pressure washer or water-jet to clean the unit.
• The unit should be cleaned right after unpacking and before turning it on.
• The unit should be cleaned with warm water and mild soap.
• Make sure to cover the fan motor to prevent moisture damage.
• Dore gaskets, shelves and supports should be cleaned on a regular basis.
• Fan blades and guards should be cleaned with a soft cloth.
5.1 Cleaning and maintenance
• All maintenance services need to be performed after disconnecting the
equipment from power supply!
• Protect electrical components against any damage or water spillage.
• Do not use water stream to clean the equipment, only a moist cloth.
• Do not use any sharp objects to remove dirt!
Figure
7 Manner of assembling/pulling out the blow in and suction
1
– Bottom surface
2
– Blow-in (DO NOT BLOCK the holes!!!)
3
– Suction (DO NOT BLOCK the holes!!!)