11www.iGOelectric.com
DISPLAY & FUNCTIONS
ERROR CODES
It is possible for a system error to occur.
When this happens, the display will show an error-code which will allow you or your
dealer to easily and properly diagnose an error in the electrical system of your ebike.
Error 1: Problem with the 3-phase control from the electronic controller
Error 2: Problem with the throttle connection
Error 3: Motor 3-phase wire is loose or defective
Error 4: Motor Hall Sensor signal malfunction (malfunction in motor or cable)
Error 5: Malfunction in brake sensor (signal)
Error 6: Battery voltage is too low
Error 7: Motor is stalled
Error 8: Malfunction in the electronic controller (signal)
Error 9: Malfunction in the display (signal)
If error persists contact iGO Technical Support
iGO TECHNICAL SUPPORT (phone lines open Mon-Fri 9:00 am - 5:00 pm EST)
tel:1 866 996 6686 email: support@iGOelectric.com
To Next Page
Loading...
