20 www.iGOelectric.com
ADJUSTING YOUR ERGOFIT EBIKE
INSTALLING YOUR STEM
Before inserting stem onto fork tube please loosen 2 side
screws using a 4mm allen key gure 20.2
Slide the stem lock on the left side down to unlock and lift lever. Figure 21.4, 21.5
Push stem down to its lowest position and insert the 5mm allen
key into stem as show in gure 20.3 and tighten.
Push down onto the lever to its original down position untill it locks back into place.
Check to make sure that handlebars are centered to front wheel
and tighten 2 stem side screws using 4mm allen key.
Fig. 20.3Fig. 20.2
Fig. 20.1
FRONT LED LIGHT INSTALLATION
Identify the light bracket
mounting bolt and nut.
Assemble as seen in gure 20.1
using a 4mm allen key.
Make sure that the light bracket is in
same position before attaching to light.
To Next Page
Loading...
