The unit comes with a CR-2450 back-up battery installed to provide continuous alarm operation and clock settings in
the event of a temporary power failure. Remove the battery pull tab before use. When the battery icon on the clock
display is flashing, it is time to replace the back-up battery. The battery compartment is located on the bottom of the
unit.
1. Make sure the AC adapter is connected, or you will lose your time and alarm settings during battery
replacement.
2. Use a Phillips screwdriver to open the battery compartment door.
3. Remove the exhausted battery from the compartment and insert 1 CR-2450 battery, checking that the + side is
facing you. Replace the compartment door. Do not overtighten.
WARNING: Lithium batteries can explode or cause burns if disassembled, shorted, recharged, exposed to water,
fire, or high temperatures. Do not place loose batteries in a pocket, purse, or other container containing metal objects,
mix with used or other battery types, or store with hazardous or combustible materials. Store in cool, dry, ventilated
area. Follow applicable laws and regulations for transport and disposal.
Do not ingest the battery, Chemical Burn Hazard. This product contains a coin/button cell battery. If the
coin/button cell battery is swallowed, it can cause severe internal burns in just 2 hours and can lead to death.
Keep new and used batteries away from children. If the battery compartment does not close securely, stop
using the product and keep it away from children. If you think batteries mtight have been swallowed or placed
inside any part of the body, seek immediate medical attention.”
CAUTION – RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN INCORRECT TYPE. DISPOSE OF
USED BATTERIES ACCORDING TO THE INSTRUCTIONS.
Maintenance
Place the unit on a level surface away from sources of direct sunlight or excessive heat.
Protect your furniture when placing your unit on a natural wood and lacquered finish. A cloth or other protective
material should be placed between it and the furniture.
Clean your unit with a soft cloth moistened only with mild soap and water. Stronger cleaning agents such as
thinner or similar materials can damage the surface of the unit.
IMPORTANT SAFETY INSTRUCTIONS
Please heed all warnings, read and follow all instructions and keep these instructions handy for future reference.
1. Do not use this product near water, and clean only with dry cloth.
2. Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions.
3. Heat – This product should be situated away from heat sources such as radiators, heat registers, stoves or
To Next Page
Loading...
