Iiyama ProLite E2207WS - Connecting Your Monitor

ENGLISH
 Ensure that both the computer and the monitor are switched off.
 Connect the computer to the monitor with the signal cable.
 Connect the monitor to the audio equipment with the Audio Cable for computer when using the
audio features.
 Connect the Power Cable to themonitorrstandthentothepowersupply.
NOTE  The signal cables used for connecting the computer and monitor may vary with the type of
computer used. An incorrect connection may cause serious damage to both the monitor and
the computer. The cable supplied with the monitor is for a standard 15 pin D-Sub connector.
If a special cable is required please contact your local iiyama dealer or regional iiyama
ofce.
 For connection to Macintosh computers, contact your local iiyama dealer or regional iiyama
ofceforasuitableadaptor.
Makesureyoutightenthengerscrewsateachendofthesignalcable.
BEFORE YOU OPERATE THE MONITOR 7
CONNECTING YOUR MONITOR
[Example of Connection]
NOTE
Power Cable
(Accessory)
D-Sub Cable
(Accessory)
DVI-D Cable
(Accessory)
Audio Cable
(Accessory)