Iiyama ProLite E2482HS - FITTING and REMOVAL of BASE: Prolite B2482 HS

ENGLISH
BEFORE YOU OPERATE THE MONITOR 7
CAUTION

Put the monitor on a stable surface. The monitor may cause injury or damage if it
falls or is dropped.

Do not give a strong impact to the monitor. It may cause damage.

Unplug the monitor before removal or installation to avoid an electric shock or a
damage.
<Removal>
Put a piece of soft cloth on the table beforehand to prevent the monitor from being scratched.
Laythemonitoratonatablewithfrontfacedown.
Loosen the ‘thumb screw’ to remove the Stand-Base from the monitor.
<Installation>
Put a piece of soft cloth on the table beforehand to prevent the monitor from being scratched.
Laythemonitoratonatablewithfrontfacedown.
Install the Stand-Base as shown on the above picture.
Tighten the ‘thumb screw’ to secure the Stand-Base to the monitor.
Stand-Base
Hook
Thumb screw for Stand-Base
Stand-Base
FITTING AND REMOVAL OF BASE : ProLite B2482HS