Iiyama ProLite E2482HS - FITTING and REMOVAL of BASE: Prolite E2482 HS

ENGLISH
8 BEFORE YOU OPERATE THE MONITOR
CAUTION

Put the monitor on a stable surface. The monitor may cause injury or damage if it
falls or is dropped.

Do not give a strong impact to the monitor. It may cause damage.

Unplug the monitor before removal or installation to avoid an electric shock or a
damage.
<Removal>
Put a piece of soft cloth on the table beforehand to
prevent the monitor from being scratched. Lay the
monitoratonatablewithfrontfacedown.
Keep pressing the Hooks inward to pull out the Stand-
Base.
Press the Hook on the back of the monitor and remove
the Stand-Neck from the monitor.
<Installation>
Put a piece of soft cloth on the table beforehand to
prevent the monitor from being scratched. Lay the
monitoratonatablewithfrontfacedown.
Hold the monitor and install the Stand-Neck to the
monitor until it clicks to secure.
Install the Stand-Base to the Stand-Neck until it clicks
to secure.
Place the Cable Holder.*
* The cable holder cannot be removed once attached.
NOTE
FITTING AND REMOVAL OF BASE : ProLite E2482HS
Hooks
Hook
Stand-Base
Stand-Neck
Cable Holder