Iiyama ProLite E2482HS - Page 33

ENGLISH
28 OPERATING THE MONITOR
1) Adjust the Horizontal Position so that the left side of the picture frame will move to the
left edge of the display area.

When the left side of the picture frame moves apart from the left edge of the display
areaduringthePixelClockadjustment,adjuststeps1)and2).

Another way to make the Pixel Clock adjustment is to correct the vertical wavy lines
in the zebra pattern.

The picture may flicker during the Pixel Clock, Horizontal Position and Vertical
Position adjustments.

In case the picture frame is bigger or smaller than the data display area after the
Pixel Clock adjustment, repeat steps from
.
2) Stretch the right side of the picture frame to the right edge of the display area by
adjusting the Pixel Clock.
Perform the auto adjustment. (Auto Adjust)
 Adjusttheimagemanuallybyfollowingprocedurebelowwhenthescreenhasaickeror
blur,orthepicturedoesnottinthedisplayareaafterperformingtheAutoAdjust.
 AdjusttheVerticalPositionsothatthetopandbottomofthepictureframewillttothe
display area.
NOTE