IKA
-WERKE C 2000 basic / control Ver. 04 08.07
3DJH
If the system check was interrupted with &DQFHO, no measurements are possible. It
is also not possible to reach the maintenance menu. Canceling is useful if only ad-
ministrative tasks (library, simulation, or evaluation) are to be performed on the calo-
rimeter.
The interrupt is confirmed with 2.; the system check is continued with %DFN.
If the system check still does not permit operation in the set operating mode after 3
minutes, it is possible to adjust the system to the appropriate mode corresponding to
the measured cooling water temperature with the &KDQJH button.
In this case a reference appears to the effect that there may be no valid calibrations
available for the selected operating mode.
RSHUDWLRQ
V\VWHP FKHFN
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
