13
032007
Page
CE-Declaration of conformity 2
Safety instructions 13
Correct use 15
Unpacking 15
Useful information 16
Drive 16
Assembly of boom and stand 17
Working with the unit 17
Maintenance and cleaning 18
Accessories 18
Speed table 18
Permitted dispersion tools 19
Faults and troubleshooting 20
Warranty 21
Technical data 21
For your protection
• Read the operating instructions in full before starting up and
follow the safety instructions.
•
Keep the operating instructions in a place where they can be
accessed by everyone.
• Ensure that only trained staff work with the appliance.
• Follow the safety instructions, guidelines, occupational health
and safety and accident prevention regulations.
• Wear your personal protective equipment in accordance with the
hazard category of the medium to be processed. Otherwise
there is a risk of:
- splashing liquids
- body parts, hair, clothing and jewellery getting caught.
• Check the appliance and accessories
beforehand for damage each time you
use them. Do not use damaged com-
ponents.
• Removable parts must be refitted to
the appliance to prevent the infiltration
of foreign objects, liquids etc.
• Do not operate the appliance in
explosive atmospheres, with hazar-
dous substances or under water.
• There may be electrostatic dischar-
ges between the medium and the
dispersing instrument shaft which
could pose a direct danger.
• The appliance is not suitable for
manual operation.
• Set up the stand in a spacious area
on an even, stable, clean, non-slip, dry
and fireproof surface.
•
Ensure that the stand
does not start to move.
• The agitated vessels used for stirring have to be secured. Con-
sider on a good stability of the entire structure.
• Secure the stirring vessel against twisting.
• Glass vessels must always be secured with a clamp to prevent
them spinning. When working with flasks elastic couplers must
be used to prevent fracture of the glass.
• Note the operating instructions of the dispersing tool and accessories.
• Only dispersing elements approved by IKA may be used.
• Assemble exactly the dispersion tool following the instructions.
• Please observe the permitted speed for the dispersing element.
Never set higher speeds.
• Do not use the appliance without a dispersing element.
• Use the dispersing tool always inside the stirring vessel.
• Check that the turning handles are secure and tighten if necessary.
• Make certain that the unit is set at the lowest speed before com-
missioning; otherwise, the unit will begin running at the speed
last set. Gradually increase the speed
.
Contents
Safety instructions
EN
Fig. 3: Points of danger
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
