START BY EMERGENCY BATTERY
Emergency battery
Breakdown vehicle battery
Ground (metal) point of breakdown
vehicle
When the battery power loss occurs,
the emergency battery or the battery of
breakdown vehicle can be used to help
to start the engine. To avoid the risk of
explosion, please connect the battery
as follows.
Check terminal voltage of the
emergency battery (12V)
- Keep two contacts of breakdown
vehicle unchanged. When the relief
vehicle battery is used, the engine
should be stopped and the two
Note:
During the operation, do not touch
the metal part of the clip. Do not
lean on the battery to avoid personal
injuries.
Remove the wires in the sequence
reverse to the connection and avoid
short circuit.
vehicles should not contact with
each other.
- Connect the battery wires in the
specied order as shown above,
and the clips should be clamped
(avoiding the sparks).
- Start the engine of relief vehicle and
make it run at higher speed for about
1 minute.
- Start the breakdown vehicle.
To Next Page
Loading...
Need help?
General
